«

»

Jun 03

How Plumbing Is Installed

How Plumbing Is Installed

 

The plumbing system follows a very simple rule which is the water must come in and come out. In a new residential property, the plumbing system is composed of three major components – the system that supplies the water, drainage system as well as the appliance or fixture set. Depending on where you are located, there are laws governing the installation of plumbing systems. There are those that require the work to be done by a licensed plumber or must be overseen by one. Local codes are also the basis of the plumbing procedures to be followed. The layout of each home is different so as the fixture placement inside the house, the diagram of the pipe routes as well as the size of pipes to be used.

Before the concrete is poured over the foundation of the house, the sewer system must be in place and set. The rough phase for the plumbing system is done together with the installation of the wiring and the duct but the framing must be completed first. Once the rough phase is done then the dry wall may be hanged. Once this is done, the main drains may be installed on the floors and make sure they are connected in stack. It will be followed by the drain fittings of the sinks and tubs. Once that is finished, the pipes of the water supply may be installed along with the flanges of the toilet.

Before the walls are framed, it is important to install the tubs or shower unit as some of them may be bigger and may not fit in once the doorways are already framed. After setting, cover them to ensure it does not suffer scratches during the remaining construction phase. Once the walls and floors are set, the sinks as well as the commodes may be installed and connected.

Be sure to check the water system. There should be two lines – one for hot water while the other is for cold water. If you are not sure how to do plumbing properly, contact professionals such as Pro Jett Plumbing & Drainage.

Share This: